Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 54)

“0” through “9”, and “A” through “F”. The chart on the back page of this manual will help

you translate decimal card addresses into hexadecimal card addresses.

The “(show #)” is the desired showʼs position in the AutoDownload list when the

AutoDownload ﬁle is saved. The ʻ(show #)ʼ represents a two digit ASCII hexadecimal

number for the desired show. Valid characters are “0” through “9”, and “A” through “F”.

The chart on the back page of this manual will help you translate decimal show numbers

into hexadecimal show numbers.

1) Echo Commands:

! “a”(card address)! ! ! ! ! ! ! Echo On:

! “b”! ! ! ! ! ! ! ! ! ! ! ! Echo Off:

The ʻEcho ONʼ command will turn on a special mode that will cause all

the other serial port commands to echo on the selected card. This used

when you are setting up serial commands so you can verify all the com-

mands you are issuing are being received correctly. In the following exam-

ples, the ʻechoʼ responses are shown in bold italics:

If you send “a00”, on the card addressed at 00h the echo mode will be

turned ON:

“card __0, echo mode”

If you send “*03A” to request a speciﬁc show on all cards:

“card __0, requested show __3 ShowName3”

If you send “t00A” to start the requested show playing on a speciﬁc card:

“card __0, starting show __3 ShowName3”

If you send “!00A” to start a show looping on a speciﬁc card:

“card __0, looping show __4 ShowName4”

If you send “uA” to stop all shows playing on all cards:

“card __0, stopped show __5 ShowName5”

Error messages will be returned whenever you ask the card to do some-

thing that it cannot do at the current time.

The ʻEcho OFFʼ command turn off the echo mode on all the cards in the

system. It does not echo anything.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 54 of 60

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 54