Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 15)

Br-ANA Connectors

A) Z-Brick

(One Twenty Pin IDS Header)

This connector is used to control one or more Z-Bricks. When enabled,

the Br-ANA outputs data from the DMX-512 input or onboard Flash Memory

to this connector. The format of the data is as follows:

IDS pin #

SIGNAL

Data bit 0

Data bit 1

Data bit 2

Data bit 3

Data bit 4

Data bit 5

Data bit 6

Data bit 7

Address bit 0

Address bit 1

Address bit 2

Address bit 3

Address bit 4

Address bit 5

Address bit 6

Address bit 7

ground

Strobe/

Reset/

When the address and data lines are valid, the rising edge of the Strobe

line will latch the data into the addressed outputs.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 15 of 60

The Z-Brick connector is a legacy connection. It is there just for backwards-compatibility on existing systems. It is highly recom-

mended that you do not use the Z-Brick connector for attaching Z-Bricks. Instead, just send DMX-512 to them just as you would for

any other GilderGear. The Z-Brick connector will likely not be installed unless speciﬁcally requested on new builds of Br-ANAs.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 15