Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 49)

F) Continue Show:

The opposite of the ʻPauseʼ Input Action, this will allow a paused show to

return to playing. On the LCD display and Br-ANAʼs menus, the show status

will be shown as ʻloopingʼ or ʻplayingʼ, depending on what its status was be-

fore the ʼpauseʼ.

G) E-stop Show:

This stops a sequencer playing immediately, and prevents the sequencer

from being restarted until the ʻClear E-Stopʼ input action is received, or the

Br-ANA is reset.

Use the drop down to the right of the Input Action to select whether this

Input Action will freeze the outputs at the ʻCurrent Frameʼ or outputs the ﬁrst

frame of a speciﬁc show (Analog outputs will be EasedIn so they donʼt

jump). All the shows in the AutoDownload list will be shown in the drop

down, and you can select the speciﬁc one you would like to use for E-Stops.

Freezing at the current frame is used when additional movements on the

analog outputs is more hazardous than leaving them right where they are

(which is often the case on motion bases).

Jumping to the ﬁrst frame of a speciﬁed show allows you to deﬁne the E-

Stop output levels for all analogs and digitals. Use this to turn on emergency

lighting, open doors, and return all outputs to a safe ʻhomeʼ position.

The E-Stop Input Action is most commonly used on the ʻopeningʼ edge

input. This is so a wire break or other fault between the Br-ANA and an E-

Stop button will ʻfail safeʼ on the Br-ANA.

On the LCD display and Br-ANAʼs menus, the show status will be shown

as ʻE-Stopʼ, to indicate that the sequencer has been locked up and will not

be allowed to start any other shows until the E-Stop is E-Cleared.

H) Clear E-stop:

This just clears the lock that the E-Stop puts on a sequencer. This lock

prevents it from starting any other shows until it has been cleared.

The ʻClear E-Stopʼ Input Action is most commonly used on the closing

edge of the same input that triggers the E-Stop. This is so that pulling the E-

Stop mushroom switch back to itʼs ʻreadyʼ position will also clear the E-Stop

lockout.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 49 of 60

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 49