Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 10)

ing to the Br-ANA's edge connector with a mating connector. We usually recommend a

sixty position insulation displacement connector for this type of installation.

Power requirements for Br-ANAs are 15 to 24 VDC. This is needed to allow some

ʻhead roomʼ for the circuitry to output the 0-10 volt levels. The actual current require-

ments are determined by the loads attached to the unit (up to 50 ma. per output). The

Br-ANA itself draws approximately 200 ma..

The revision 4.nn Br-ANA$ is an upgrade from all earlier version of the Bs-ANA and

Br-ANA. The chief differences are:

1) Standard removable Sd or SdHC ﬂash cards are now used for show data

storage.

2) Supports a full 512 channel DMX-512 universe on input or output

3) Supports v1.1 AutoDownload ﬁles

4) Automatic recognition and support for GilderChecksums

5) Field upgradable ﬁrmware. Updates can be installed by just putting the ﬁrm-

ware ﬁle onto the Sd card and inserting it into the Br-ANA

Customized front panel artwork is available on all GilderGear, including the Br-ANA.

These can be custom branded, or labeled for speciﬁc installation names. Please contact

the Gilderﬂuke & Company factory for details on generating custom Br-ANA labels.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 10 of 60

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 10