Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 35)

(addresses 2, 5, 8, 11, etc.) will need to have the previous two addresses

sent (or burnt into the Flash Memory) so that its lowest four bit nibble isnʼt

lobbed off.

C) Sequencer Enabled:

This toggle enables and disables the Br-ANA to use the Animation Data

Flash Memory. When it is OFF, nothing will be output from the AutoDown-

load ﬁle stored on the micro Sd/SdHC ﬂash card. Any output data must

come from either the DMX-512 or Serial Port inputs. If it is ON, then the data

from the AutoDownload ﬁle on the micro Sd/SdHC ﬂash card will be sent

out.

D) DMX-512 mode:

If using a v1.1 AutoDownload ﬁle generated with Pc•MACs version

2.02.212.xxx or later, this will be set automatically for you from data in the

AutoDownload ﬁle.

If there isnʼt a v1.1 AutoDownload ﬁle being used, this command is a tog-

gle which can be used to enable and disable the DMX-512 reception and

transmission, as well as the GilderChecksums.

The GilderChecksums allow GilderGear to recognize errors in DMX-512

data. With GilderChecksums, the outputs wonʼt be updated when a bad data

packet is received. GilderChecksums should be left ON whenever sending

DMX-512 to other GilderGear.

The Br-ANA, and most other GilderGear will automatically sense when it

is receiving GilderCheckSums. Once it does this, the GilderGear will have to

be reset before it will accept DMX-512 data without GilderCheckSums.

^d) DMX-512 Zero-Based or One-Based:

If using a v1.1 AutoDownload ﬁle generated with Pc•MACs version

2.02.212.xxx or later, this will be set automatically for you from data in the

AutoDownload ﬁle.

If there isnʼt a v1.1 AutoDownload ﬁle being used, this command is a tog-

gle between displaying DMX-512 addresses as 0-511 numbers, or as 1-512

numbers.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 35 of 60

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 35