Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur télécharger pdf (Page 47)

Optically Isolated Trigger Input Actions

The following Input Actions are used to start, stop, and generally control the Br-ANA

through its four optically isolated trigger inputs. The optically isolated trigger inputs can

be used as the sole method to control the Br-ANA, or as an adjunct to the Br-ANAʼs

primary serial port.

You set what each of the Trigger Inputs will do on the AutoDownload dialog, (usually)

after you have ﬁnished programming all of your shows and are ready to send them to

the Br-ANA.

The Br-ANA has four Trigger Inputs. You can set different Input Actions for the ʻclos-

ing Edgeʼ

on the input and the ʻopening Edgeʼ

.This allows you to do things like

ʻpauseʼ a show on a closure of an input, and then ʻcontinueʼ it on the opening of the

same input.

Pc•MACs uses the ʻTarget Deviceʼ to know what options are available for the Trigger

Inputs, number of sequencers available, and even the size of the AutoDownload mem-

ory available. It looks this up from the GilderGearList each time you do an AutoDown-

load, so if new features have been added to the Br-ANA since your last AutoDownload,

you will be able to access them.

Some of the Input Actions require you to enter a second or third value from the drop

downs just to their right. Typically these will be a show, or range of shows for the Input

Action to use.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-ANA Manual / December 18, 2012 10:21 AM / page 47 of 60

The ʻclosing edgeʼ is when current starts ﬂowing through the optically isolated input, which is usually when an attached switch

ʻclosesʼ. The status of all the Trigger Inputs can be seen on the Br-ANAʼs ʻstatusʼ command and ʻmainʼ menu.

The ʻopening edgeʼ is when current stops ﬂowing through the optically isolated input, which is usually when an attached switch

ʻopensʼ. The status of all the Trigger Inputs can be seen on the Br-ANAʼs ʻstatusʼ command and ʻmainʼ menu.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Pas de commentaire

Gilderflukeco BR-ANA Analog Output Smart/Dumb Brick Manuel d'utilisateur Page 47