Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur télécharger pdf (Page 6)

narrowed down to restrict the movement to a smaller range.

When you adjust either end of travel for your ServoMotors, it will

not affect the other endpoint at all. If you need to reverse the

movement of a ServoMotor, you can simply adjust it that way.

To help extend the life of your ServoMotors, you can also set

the SER-DMX to turn ‘off’ the ServoMotors when they aren’t need-

ed.

To keep the ServoMotors from jumping unexpectedly, an

Ease-In feature is available on the ServoMotor outputs. This al-

lows you to slow down the movement of one or more

ServoMotors when the SER-DMX is first turned on or when it first

picks up the DMX-512 command signals. You can also store the

positions you want the ServoMotors to assume as soon as power

is applied to the SER-DMX.

One or more SER-DMXs can be mounted in 2-3/4” wide

Augat Snap Track. They can also be mounted on insulated

standoffs using the mounting holes located at each corner.

Each SER-DMX has connectors on the right and left sides that

allow them to be interconnected. Power, DMX-512, and serial

port connections from any one card are bussed to all of the ad-

jacent cards.

Power requirements for each SER-DMX are nine to twenty-four

VDC at approximately 200 milliamperes. The ServoMotors also

require a separate, larger power supply. Typical ServoMotors run

on voltages of three to six volts DC (some use twelve or twenty-

four VDC), and depending on the ServoMotor, can draw several

amps of current. Most small ServoMotors are powered through

the same three conductor ‘F’ or ‘Futaba’ connector that is used

to send them their control signal. Some larger ServoMotors, like

the ‘Tone’, ‘Condor’, or CK Designs ServoMotors have separate

twelve or twenty-four volt power supply connections in addition

to the three conductor control cable.

GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX 818/840-9485

AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX 407/354-5955

2 of 22

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Pas de commentaire

Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur Page 6