Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur télécharger pdf (Page 20)

6) 2-1/2 seconds

7) 5 seconds

8) 7.5 seconds

9) 10 seconds

If any output crosses or reaches the level it is being commanded

to, it will drop out of Ease-In mode and begin following the command

normally. You can tell when an Ease-In is being performed by the

Heartbeat jumping to a speed twice normal. Once all outputs have

dropped out of Ease-In mode, the heartbeat will return to its regular

rate.

Which outputs have been set to use the Ease-In Feature is shown

under the column labeled ‘EI’. Outputs which will be Eased In are

shown by the letter ‘Y’. All other channels will be unaffected by the

Ease-In.

p) Set Analog Endpoints: This command is used to adjust the endpoints

of the sixteen ServoMotor outputs. The ‘Set Min/Max/Forced using

Keypad’ is actually a much easier way of setting these values. Use it if

you can.

The ServoMotor outputs can be adjusted to sweep anywhere be-

tween .0009 and 2.048 milliseconds. Most ServoMotors aren’t able to

follow this wide a range of pulse width. They will either run into their

mechanical ends of travel (which is not a healthy thing for a

ServoMotor) or just turn off when the command pulse gets to narrow

or too wide.

By using these commands you can set either endpoint to any-

where among .0009 and 2.048 milliseconds for a reduced (or re-

versed) motor output swing. To reverse any servo, all you need to do

is set the lower limit to a value higher than the upper limit. The end-

points for all sixteen outputs are displayed in the ‘Analog Endpoints’

columns on the display.

The endpoints can only be set for the on-board ServoMotor out-

puts. A new output address will be requested if the currently selected

'Output to Test & Adjust' is not pointing at an on-board output.

u) set Min/Max/Forced using keypad: This command is used to set the

three main variables used for each servo output output. These are

the two endpoints and forced values. This is the quickest way to set

and adjust the outputs. Once this command is invoked, the currently

selected output can be adjusted using the numeric keypad on your

computer:

a) The ‘Minimum Scale’ endpoint is set using the ‘7’ (increase the

GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX 818/840-9485

AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX 407/354-5955

16 of 22

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Commentaires sur ces manuels

Pas de commentaire

Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Gilderflukeco DMX-512 Input Servo Motor Controller