Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur télécharger pdf (Page 19)

for storing the least significant four bits of the next two twelve bit reso-

lution channels. Any twelve bit resolution channel that is addressed

at an address that can be divided evenly by three plus one (address-

es 1, 4, 7, 10, etc.) will need to have the previous address sent so

that its lowest four bit nibble isn’t lobbed off. Any twelve bit resolution

channel that is addressed at an address that can be divided evenly

by three plus two (addresses 2, 5, 8, 11, etc.) will need to have the

previous two addresses sent so that its lowest four bit nibble isn’t

lobbed off.

j) Output to Test & Adjust: This command is used to set the output ad-

dress that will be used by the 'Test Output', 'Set Analog Endpoints',

'Force analog Endpoints', 'Force output to a Value', ‘set

Min/Max/forced using keypad’, and 'set PowerOn Defaults' com-

mands. If the output address selected is one of the sixteen on the

SER-DMX, then an arrow will appear next to it on the screen. In the

example screen above you can see this arrow pointing to address

14. The data for the output which is selected using this command will

also be sent to the ‘Output Under Test’ LED on the SER-DMX.

k) Test Output: When toggled to ‘Test One Output’, the single output se-

lected by the 'Output to Test & Adjust' command will be ramped up

and down. The ramp time is about 5 seconds. The time the output

stays at each extreme is about a second. When toggled to ‘Test All

Outputs’, all of the outputs will be ramped between their two ex-

tremes. The ramp times are the same as when ramping a single out-

put.

e) Auto Ease-In: When enabled, this feature will keep all the selected

channels from jumping at a high rate of speed if:

a) The DMX-512 data starts being received.

b) An output is forced to a specific value.

c) One or more outputs are put into or taken out of the internal

test mode.

d) At boot up as the outputs assume their default positions.

This command allows you to select the amount of time any out-

put will take to ramp from one extreme to the other and which out-

puts will be using the Ease-In feature. The range of time available is:

0) Ease-In is disabled

1) 1/4 second

2) 1/2 second

3) 1 second

4) 1-1/2 seconds

5) 2 seconds

GILDERFLUKE & CO.• 205 SOUTH FLOWER STREET • BURBANK, CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX 818/840-9485

AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX 407/354-5955

15 of 22

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Commentaires sur ces manuels

Pas de commentaire

Gilderflukeco DMX-512 Input Servo Motor Controller Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Gilderflukeco DMX-512 Input Servo Motor Controller