Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 47)

m) LaserDisk/DVD End (displayed as ʻLdEndʼ):

This command tells the Br-SDC to go into a mode where it polls the attached

LaserDisk/DVD for the ʻLDP Endʼ frame that has been entered for the show that is play-

ing. If the Br-SDC doesnʼt get a response from the LaserDisk/DVD within a second, it

will try to query it again.

Once the ʻend frameʼ (or any value larger than the ʻLDP end frameʼ) has been found,

the Br-SDC will then continue with the next character in the string.

t) Start Timer (displayed as ʻtimerʼ):

You can set a ʻlengthʼ for each of the shows. This command will start an internal timer

in the Br-SDC running for the number of frames that has been set for the show ʻlengthʼ.

Valid range of frames for this timer are one frame to 99,999 frames. This translates into

a potential time delay of over nine hours.

Once the delay time has passed, the Br-SDC will then continue with the next charac-

ter in the string.

u) Rx Anything (displayed as ʻ__?__ʼ):

(Command NOT available if in Mode 1) There are times when you need to get a

character from the serially controlled device, but really just donʼt care what it is that is

returned. The string will be paused until any character is received. The string will then

continue with the next character.

v) End Of String (displayed as ʻ_end_ʼ):

This is used to mark the end of any string. When inserted into any string, the remain-

der of the string will not be displayed or sent. You can use this command to truncate a

string that is now longer than you need.

n) Eight Bit Binary value (displayed as ʻ_BIN_ʼ):

(Binary Mode only) This is used insert the binary value on the 1/4-J6 input into any

string. This is sent as a single 8 bit byte. The value can be anything from 0x00 to 0xFF.

o) Two character HEX value (displayed as ʻ_HEX_ʼ):

(Binary Mode only) This is used insert the HEXadecimal value on the 1/4-J6 input

into any string. This is sent as two 8 bit ascii bytes (0-9, A-F).

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 47 of 62

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 47