Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 19)

Br-SDC Input Setup Menu

The Trigger Setup menu will appear as follows (Br-SDC/09 shown):

This screen is used to set what happens on each of the ten switch closure inputs.

Different actions can be chosen for the opening or closing edge of each input. The op-

tions are:

1) Which of the ﬁfteen possible strings (0=none, 1-F) will be sent on this input/

edge.

2) If a ʻDelayʼ marker (ʻTIMERʼ) is found in the string, how long (in 30 FPS or 25

FPS frames) the delay will be.

3) If a DVD ʻSearchʼ marker (ʻSERCHʼ) is found in the string, then what frame

number on the DVD will be searched for.

4) String to send at end of this string, if it completes successfully.

5) String to send at end of this string, if it encounters an error while sending this

string.

Several commands are shown at the top of the screen. Below this are the actions

that will take place one each of the ten optically isolated inputs. Each of these inputs

has both a ʻclosingʼ edge (shown by a ʻcʼ) and opening edge (shown by an ʻoʼ) action. If

a) Pioneer CAV, b) 9600 baud, c) clear, d) save, e) string, f) 30 FPS, 9) mode

Input 2 close:1) string, 2) delay, 3) dvd start/end, 4) @end, 5) @fail, 6) kopy

g) 0 c:

h) 0 O:

i) 1 c:

j) 1 O:

K) 2 c: STRING-3 | DELAY-123,456 | DVD-123,456 / END-654,321 | @END-4 | @FAIL-5

l) 2 O:

m) 3 c:

n) 3 O:

o) 4 c:

p) 4 O:

q) 5 c:

r) 5 O:

s) 6 c:

t) 6 O:

u) 7 c:

v) 7 O:

w) 8 c:

x) 8 O:

y) 9 c:

z) 9 O:

Enter Command-

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 19 of 62

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 19