Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 40)

When a Br-SDC8 is in mode0, the string menu is disabled, and the trigger

menu is drawn with all but four commands disabled, with instructions for the multi-

plexer mode:

Which ports are used are selected in one of three ways:

1) ATT+++ commands: Nine ʻspecialʼ strings will be intercepted by the Br-SDC8,

and not passed through to the outputs. When it receives one of these special

strings, instead of passing the string through to the currently selected male DE-

09 plug(s), the Br-SDC8 will use it to select a different port for sending and re-

ceiving serial data.

String

Sent

Multiplexer

Selected

AT+++0 <CR>

AT+++1 <CR>

AT+++2 <CR>

AT+++3 <CR>

Tx = ALL, Rx = #1

Tx = #1, Rx = #1

Tx = #2, Rx = #2

Tx = #3, Rx = #3

b) 9600 baud, c) clear to default, d) save configuration thru serial, 9) mode 0

Serial Multiplexer (Mode 0) selected:

no strings or shows are available

use J6 bits 0, 1, 2 and 3 of J6 or AT+++ commands to select multiplexer channels

00000000b / 00h / __0

Enter Command-

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 40 of 62

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 40