Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 48)

If you are building a string to use with another piece of Gilderﬂuke equipment, this will

probably be the way you will want to send it a binary value from the 1/4-J6 port. A typical

string to select and loop a show looks like this:

|_2Ah_|_HEX_|_22h_|_end_|

The ﬁrst character is the ʻ*ʼ (2Ah) that is used for the ʻglobal show selectʼ command.

The two digit HEXadecimal value from the 1/4-J6 is sent next (shown by the ʻ_HEX_ʼ).

The ʻglobal loopʼ command ʻ“ʻ (22h) is sent to start the selected show looping.

p) Three character BCD value (displayed as ʻ_BCD_ʼ):

(Binary Mode only) This is used insert the Binary Coded Decimal (BCD) value on the

1/4-J6 input into any string. This is sent as three 8 bit ascii bytes (0-9). Three characters

are always sent, so it is led by ʻ0ʼs if the value is less than 100. Two zeros lead values of

ʻ9ʼ and below.

o) Transmit to ALL, Receive from #1:

1) Transmit to #1, Receive from #1:

2) Transmit to #2, Receive from #2:

3) Transmit to #3, Receive from #3:

4) Transmit to #4, Receive from #4:

5) Transmit to #5, Receive from #5:

6) Transmit to #6, Receive from #6:

7) Transmit to #7, Receive from #7:

8) Transmit to #8, Receive from #8:

(Available in mode #1 ONLY) Commands can be embedded into the strings that se-

lect the following:

String

Entry

Multiplexer

Selected

Mux0

Mux1

Mux2

Mux3

Tx = ALL, Rx = #1

Tx = #1, Rx = #1

Tx = #2, Rx = #2

Tx = #3, Rx = #3

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 48 of 62

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 48