Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 45)

i) Edit Entry nn:

This command displays the entry within the selected string (1-99) that will be

changed by the next string altering command (value to get, value to send, etc.). When a

new string is selected, this is reset back to the ﬁrst entry in the selected string. Each

time you make an entry in a string, this value is automatically incremented to the next

entry. If you make a mistake in a string, you can use this command to go back a few en-

tries and make your corrections.

s) Tx Value:

This adds an entry in the selected string (shown by ʻh) Edit String nʼ) at the entry

(shown by ʻi Edit Entry nnʼ). The Br-SDC will ask you for a Hexadecimal value (00-FF),

which will be sent out as part of the string. This will be displayed on this menu as a

hexadecimal value. You can make multiple entries, which will be added to consecutive

entries in the selected string. Enter an <Escape> when you are ﬁnished making entries.

g) Rx Value:

(Command NOT available if in Mode 1) This adds an entry in the selected string

(shown by ʻh) Edit String nʼ) at the entry (shown by ʻi Edit Entry nnʼ). The Br-SDC will

ask you for a Hexadecimal value (00-FF). This will be displayed on this menu as a

(hexadecimal value). The parenthesis show that this is a character that the Br-SDC will

pause until it is received. If a different character is received, this will generate an ʻerrorʼ.

A different string can be triggered if there is an error in a string. You can make multiple

entries, which will be added to consecutive entries in the selected string. Enter an <Es-

cape> when you are ﬁnished making entries.

h) Kopy:

This command asks you for the number of another string. When you enter it, the en-

tire contents of the requested string is copied to the currently selected string.

j) Tx Text:

This command is an alternative way to enter data to send as ASCII text (instead of

entering characters as hexadecimal values, as done in the ʻs) Send a Valueʼ command).

You simply type the ascii text to send. This will add a ʻtextʼ entry in the selected string

(shown by ʻh) Edit String nʼ) at the entry (shown by ʻi Edit Entry nnʼ). This will be dis-

played on this menu as an ascii text character, within a single pair of quotes. You can

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 45 of 62

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 45