Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 42)

Binary

Number

Bit3

Pin #6

(+8)

Bit2

Pin #7

(+4)

Bit1

Pin #8

(+2)

Bit0

Pin #9

(+1)

Multiplexer

Selected

Off

Tx = #8, Rx = #8

This mode is often used with a PLC or other controller, where GPIOs are

available for making the binary selections.

Note that when using the binary inputs, it is not possible to transmit through

more than one multiplexer output at one time, unless you want to transmit to all

of them simultaneously.

You donʼt want to switch between multiplexers in the middle of a message.

Make sure that the last serial message has completed transmission before you

change the selected multiplexer.

3) (Available in mode #1 ONLY) Commands can be embedded into the strings

that select the following:

String

Entry

Multiplexer

Selected

Mux0

Mux1

Mux2

Mux3

Mux4

Mux5

Mux6

Mux7

Mux8

Tx = ALL, Rx = #1

Tx = #1, Rx = #1

Tx = #2, Rx = #2

Tx = #3, Rx = #3

Tx = #4, Rx = #4

Tx = #5, Rx = #5

Tx = #6, Rx = #6

Tx = #7, Rx = #7

Tx = #8, Rx = #8

Note that when using the binary inputs, it is not possible to transmit through

more than one multiplexer output at one time, unless you want to transmit to all

of them simultaneously.

2) Mode 1: This mode of operation is combination of mode 0 and mode 2. Strings

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 42 of 62

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Gilderflukeco BR-SDC Serial Device Controller