Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur télécharger pdf (Page 22)

a) LaserDisk/DVD Player type:

This command is used to select which type of LaserDisk/DVD is going to be used

with the Br-SDC. Supported types are Pioneer or Sony. For each of these, you can also

select whether it will be using a standard CAV (thirty minutes maximum length) disk, or

an extended CLV (60 minutes maximum length) disk. DVDs all use frame references,

and numbers from 1 to 9,999,999 are valid (assuming there are that many frames re-

corded on your disk!).

CAV disks use frame number references between one and 54,000 frames. CLV disks

use time references between 0:00:00.01 and 9:59:59.29. The display on this screen will

be modiﬁed to show the appropriate numbering system for the LaserDisk/DVD selected.

You can switch back and forth between CAV and CLV disk formats to review the

frame numbers you have entered either in ʻframesʼ or ʻtimeʼ formats.

If using a Pioneer DVD-V7200, DVD-V7400 (or their PAL equivalents DVD-V7100 or

DVD-V7300), you should set the Br-SDC for ʻPioneer CAVʼ mode.

b) Baud Rate:

This command toggles among the eight supported baud rates:

1) 1200 baud

b) 9600 baud, c) clear to default, d) save configuration thru serial, 9) mode 0

Serial Multiplexer (Mode 0) selected:

no strings or shows are available

use J6 bits 0, 1, 2 and 3 of J6 or AT+++ commands to select multiplexer channels

00000000b / 00h / __0

Enter Command-

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-SDC Manual / December 30, 2013 9:24 AM / page 22 of 62

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Pas de commentaire

Gilderflukeco BR-SDC Serial Device Controller Manuel d'utilisateur Page 22