Gilderflukeco Br-miniBrick8 Manuel d'utilisateur télécharger pdf (Page 24)

Setting Operating Modes:

Press and hold the red ʻRecordʼ button. Press the red ʻRecordʼ button nine to twelve

more times, until you see the green ʻtriggerʼ LED and one of the four output indicators

ﬂashing a two short / one long pattern:

a. Output 0 & ʻtriggerʼ LEDs: Play once, no step

b. Output 1 & ʻtriggerʼ LEDs: Play once, steppable

c. Output 2 & ʻtriggerʼ LEDs: looping, no step

d. Output 3 & ʻtriggerʼ LEDs: looping, steppable

Press and hold the red ʻRecordʼ button for three seconds to lock in the desired oper-

ating mode.

A show that is set to ʻplay onceʼ will only play when triggered, and then stop and wait

for the next trigger. A ʻloopingʼ show will start playing at PowerUp, and loop back to itself

at its end. It loops until powered down.

A show that is set to ʻno stepʼ will not allow another show to be started once it has

been started. This is used to keep shows from being retriggered repeatedly. It is used if

your show is started by a step pad, motion sensor, or other device which will send addi-

tional ʻstartʼ pulses before the show has run its course.

A shortcut to stop the Br-miniBrick8 playing or exit any ʻprogrammingʼ mode is to

release the red ʻRecordʼ button and quickly press the blue ʻDataʼ button three times.

This stops any show which was playing.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-miniBrick8 v3.+ Manual / 8/17/12 / page 18 of 36

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Pas de commentaire

Gilderflukeco Br-miniBrick8 Manuel d'utilisateur Page 24