Gilderflukeco Br-miniBrick8 Manuel d'utilisateur télécharger pdf (Page 17)

Conﬁguration Menu

If you arenʼt using the ServoMotor outputs, you will not need to conﬁgure the Br-

miniBrick8. Even if you are using the ServoMotor outputs, you will only rarely need any

changes to the conﬁguration. Using GIlderTerm, plug in the serial cable to the Br-

miniBrick8. Press the ʻconﬁgureʼ button to bring up the following menu:

As you can see, there arenʼt too many options available on this menu.

Set DMX-512 Address

This command is used to set the offset address for the Br-miniBrick8. By default

the Br-miniBrick8 uses DMX-512 or Serial RealTIme data addressed at zero for the

digital outputs, one as the ﬁrst ServoMotor, and two as the second ServoMotor. This

command is one of two ways to set these offsets to any other address. No matter what

the base address is set to, all three data channels the Br-miniBrick8 will use are con-

secutive.

If using Serial RealTime data, keep in mind that there are only sixteen channels of

data being transmitted. If the address is set above sixteen, then the Br-miniBrick8 will

never see that data, as they are above its maximum address range.

If using DMX-512 data, feel free to set the address to anywhere between 0 and 511.

Keep in mind that most lighting boards and dimmers now number the DMX-512 ad-

dresses between 1 and 512 (our address ʻ0ʼ is their address ʻ1ʼ). If sending data from a

non-Gilderﬂuke system, you will need to offset the address of either the Br-miniBrick8

or the device which is sending the DMX-512 data by one address.

a) Address- __0

1) Servo 1 endpoints (min: 128 | max: 130)

2) Servo 2 endpoints (min: 128 | max: 140)

b) DMX-512 Receive

c) use standard Digital Gilder-DMX

x) eXit

enter command-

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Br-miniBrick8 v3.+ Manual / 8/17/12 / page 11 of 36

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Pas de commentaire

Gilderflukeco Br-miniBrick8 Manuel d'utilisateur Page 17