Gilderflukeco KP-300 Smart Brick Control Panel Manuel d'utilisateur télécharger pdf (Page 47)

so that the ride is added to the running count.

i) After the ʻCycle Counterʼ has been pulsed, and all the motion

base axis have returned to the 0% position, the ʻBlocking Valveʼ

Enable is turned back off. This disables all movement on the mo-

tion base.

j) (optional) Close any cabin doors as needed at show start. Open

them again at show end. Sometimes cabin doors are manually

operated, sometimes they are automated. If they are automated,

they usually need to be programmed to close (or stay closed)

during the Main Shows, and then opened again at the showsʼ

end. Kp-300 safety switches are normally used to monitor the

safe positions of ramps and doors, and pause and/or E-Stop if a

ramp or door leaves the ʻsafeʼ position.

k) (optional) Turn on/off any lights as needed.

l) Start the audio/video for the motion base.

m)If you are controlling a Moog electric motion base, you will need

to program in a Moog Engage command at the start of the show.

The motion base will receive this, and move into the start posi-

tion. Note that the command signals to the Moog motion base

must be in the EXACT right values, or the motion base will enter

an error mode instead of the ʻengagedʼ mode. This process

takes a few seconds, so allow for it in the timing of your show

programming. At the end of a Moog motion base show, you will

need to issue a Moog Park command after ﬂying the base to as

close to the parked position as you can get.

n) At the end of the main shows, they all typically jump to a com-

mon Load/Unload show. This will loop back on itself and is pro-

grammed to ﬂash the appropriate Show Start Button LEDs and

turn on the appropriate Show Start Button Enable Input.

AutoDownloading Shows for a Kp-300

Once you have your shows programmed using Pc•MACs and ready to down-

load to the Br-Brain4, AutoDownloading them is simple.

1) Target Device: By default, Pc•MACs will have selected your ʻtargetʼ

device. This will probably be a Br-Brain4.

2) Shows In Device: Use the ʻAddʼ button to add all of your shows to

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Kp-300 Manual / September 4, 2012 4:29 PM / page 47 of 75

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 74 75

Pas de commentaire

Gilderflukeco KP-300 Smart Brick Control Panel Manuel d'utilisateur Page 47