Gilderflukeco old Smart Brick Manual Manuel d'utilisateur télécharger pdf (Page 88)

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥

ÒoÓ Load Defaults:

This command allows you to reload the default configuration settings shown in the menu above.

ÒxÓ eXit Setup Mode:

This command is used to exit the setup mode. If you hit this command in error, hitting an <ESC>ape

key will get you back to the setup mode. All of the setup commands which don't take effect immediate-

ly, take effect when the eXit command is entered. This includes things like the BAUD RATE, so you will

have to change the baud rate of the terminal you are using at this time.

For compatibility with other products which might be on the same RS-422 serial network, this com-

mand asks you to enter a ÔYÕ or ÔNÕ. This lets them know that the setup mode has been exited on this

card. If you hit this command by mistake, then you can hit the <ESC>ape key to get back to where you

were before.

All other Audio Repeater cards and Brick Brains in the same serial network have their serial ports dis-

abled while any card in the system is in setup mode. This is the only command to which they will re-

spond. After the initial 'X', all of the other cards wait for a 'Y' or 'N' before they will start accepting other

serial commands again. If you find that you are having trouble communicating with any of the cards in

the system, try entering an ÔXNÕ to trick it into thinking you have exited the configuration mode.

GILDERFLUKE & C

.¥ 205 S. FLOWER ST.¥ BURBANK, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485

78 of 134

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 143 144

Pas de commentaire

Gilderflukeco old Smart Brick Manual Manuel d'utilisateur Page 88